Hi

I'm having problems logging into an imap account. The client response is 'The IMAP server is not responding correctly'.

The debug log shows the following:

[ Wrote ] mw1 L<password not logged>
[ Read ] * OK [CAPABILITY IMAP4REV1 LOGIN-REFERRALS AUTH=LOGIN] imap2 IMAP4rev1 2001.305 at Sun, 2 Nov 2003 22:46:27 +0000 (GMT)
[ Read ] * CAPABILITY IMAP4REV1 IDLE NAMESPACE MAILBOX-REFERRALS SCAN SORT THREAD=REFERENCES THREAD=ORDEREDSUBJECT MULTIAPPEND
[ Read ] mw1 OK LOGIN completed
[ Wrote ] mw2 SELECT INBOX
[ Read ] * 223 EXISTS
[ Read ] * 224 EXISTS
[ Read ] * 1 RECENT
[ Read ] * OK [UIDVALIDITY 1066392331] UID validity status
[ Read ] * OK [UIDNEXT 1081] Predicted next UID
[ Read ] * FLAGS (\Answered \Flagged \Deleted \Draft \Seen)
[ Read ] * OK [PERMANENTFLAGS (\* \Answered \Flagged \Deleted \Draft \Seen)] Permanent flags
[ Read ] * OK [UNSEEN 217] first unseen message in /home/gps_13/phl6lnj/mbox
[ Read ] mw2 OK [READ-WRITE] SELECT completed
[ Wrote ] mw3 STATUS inbox (MESSAGES)
[ Read ] * NO CLIENT BUG DETECTED: STATUS on selected mailbox: INBOX
[ Read ] * STATUS INBOX (MESSAGES 224)
[ Read ] mw3 NO STATUS failed: <unknown>
[ Wrote ] mw4 LOGOUT
[ Read ] * BYE imap2 IMAP4rev1 server terminating connection


Is this a server problem, or a MW Pro problem?

Thanks.

Someone will correct me if I'm wrong but I think MailWasher only works with POP3

I stand corrected disregard the above post.

If you registered you could delete your posts if nobody had replied to them yet.

The problem here is with the server, there should be no problems calling
STATUS on the currently selected Inbox, which MailWasher is doing.

It's a compile flag during the IMAP server setup, so one would hope it's just been misconfigured, rather than purposefully set this way.

Thanks rusticdog.

I'll pass this on to the mail sysadmin.